Louis area homes is when the pilot light goes out.
Furnace pilot light location.
The vent that distributes heat sits above the furnace and is covered by a metal grille at floor level.
A modern gas furnace usually has an electronic spark generator to ignite the gas when the thermostat calls for heat.
Standing pilot lights are common in older furnaces but many newer furnaces have intermittent pilot lights or hot surface igniters.
Then if possible remove the sensor from the furnace.
Knowing where the pilot light is located will be helpful in getting your furnace back up and running quickly.
An older gas furnace has a standing pilot that stays on all the time or at least it s supposed to.
Furnace pilot light troubleshooting.
One of the most common problems with aging furnaces in st.
To clean the sensor turn off power to the furnace at the breaker box.
A number of things can make an old furnace pilot light go out including a strong draft a faulty thermocouple or a loss of gas.
Locate the pilot light and look for the tip of a copper rod very nearby.
Today we re going to talk about some of the most common reasons that a gas furnace pilot light would go out and what you should do if it happens to you.
Can t find the pilot light.
In principle lighting a furnace pilot light is not terribly complicated.
Scrub the sensor gently to remove dust and other residues.
In most cases this knob has three distinct settings.
Step 1 remove the front sheet metal access panel on the front of the furnace.
Pilot off and on if you are unable to locate this assembly or knob refer to the user manual for your furnace and try to locate a diagram that can tell you where the knob or switch is on your specific unit.
Typically the flame sensor comes in the form of a rod that can be found near the back of the furnace right in the path of the burner.
Any gas furnace uses a pilot light to trigger the burners to heat your home.
Come fall time or any time your pilot light might go out it is time to re light your pilot light please thoro.
Turn off the thermostat remove a few panels to locate the pilot light light it a.
The thermocouple isn t too difficult to find.
If you re having trouble locating the pilot or thermocouple double check to make sure your unit actually has a standing pilot light.
The pilot light is typically in the bottom of the furnace near a small knob.
About press copyright contact us creators advertise developers terms privacy.
Depending on the source of the problem this can either be a one time incident or something that happens over and over again.